Basic Roller (CT01)
The CJ autos Basic car body roller puts the car on its side and lets you work standing upright.
It takes less than fifteen minutes to assemble and turn the car.
Just raise one side of the car up remove the front and rear wheel, bolt the correct hub plates on the hub, slide the holding pins through the frame to the hub plate, lower jack and attach safety bar then its ready to roll
Also, remove the battery and keep the fluids low or drained.
Tip it with the petrol neck at the top
•BY USING 2 AXLE STANDS YOU CAN KEEP THE BASIC ROLLER AT 90 DEGREES
•20 CM / 50 CM / 140 CM 37kg weight
•MAX WEIGHT 2 AND a HALF TON
•MAXIMUM WEIGHT 2500 KG.
•SUITABLE FOR USE WITH 3 - 4 AND 5 STUD WHEELS.
•CAN BE TURNED BY ONE PERSON USING AN ENGINE HOIST OR BLOCK AND TACKLE OR BY USING OUR NEW LIFTING DEVICE POWERED FROM ELECTRIC DRILL
•A car can be turned by one person using an engine hoist or block and tackle or by using our new lifting device powered from your electric drill.
•You will need approximately 2.5 meters of space. If your garage is not wide enough, our Optional Wheel Kit, illustrated here, is the answer. Fit your car to the frame outdoors, turn the car and then just wheel it back into your garage.
•Bolt the frame to the wheel hubs then remove the jack so the car is standing on the frame. Make sure the battery has been removed and the oil and fluid holes have been blanked off.
Remove both wheels on one side and attach the hub adaptors.
Attach the roller cradle to each of the wheels.
This is the Basic Roller fully built. You'll need either an engine crane, or several mates, to start the roll off. Overcoming the dead weight of the vehicle takes a lot of effort.
Basic Car Roller with Lifting Device
This lifting device will be coming back into production soon
call for more information